Skip to main content

IoT Relay to Raspberry Pi pinout

Wiring everything up was very easy. I just connect the IoT Relay (spec sheet) to the Raspberry Pi, ground to the ground and the control signal to GPIO (shown in the pinout below). I used pin 17 as my GPIO

Pull Out This Green Plastic For Access In Order To Secure Wire
Pull Out This Green Plastic For Access In Order To Secure Wire

30 Percent Black Watermark 600x338
30 Percent Black Watermark 600x338

IoT Relay To Raspberry Pi Pinout
IoT Relay To Raspberry Pi Pinout

Updated Spreadsheet Including A Column To Show If The Power Is Turned On Or Off.
Updated Spreadsheet Including A Column To Show If The Power Is Turned On Or Off.